Description:

A cement base, 2 component polymer modified high elastic waterproofing slurry. It is applied to concrete and mortar structures to prevent water infiltration.

Advantages:

• Rock Seal 777 (Elastic) provides the following beneficial properties:
• Easy application by metal spatula, roller or flat brush, sprayed, even onto vertical walls and ceiling.
• Capable of accommodating substrate flexural strains.
• Crack bridging capability, even on existent cracks or cracks that might open after the product application.
• Optimum adhesion onto almost all substrate, such as for instance concrete, Cementitious mortars, stone, ceramics, bricks and wood. Non-toxic.

Fields Of Use:

Due to its high elasticity, Rock Seal 777 (Elastic is applicable on different structures including those subject to thermal movement and vibration as: Waterproofing and protection of structures under hydraulic pressure, like water storage tanks, swimming pools, concrete pipes, bridge parapets, water canals, sewage treatment structures….etc.

Waterproofing and protection of external walls to be buried below ground.

Internal waterproofing against hydrostatic water pressure of walls and floors in basements and other below ground structures.

Waterproofing of terraces and balconies on concrete and old tiles substrates.

Protection of exposed and weathered, new and existing concrete surfaces, as anti-carbonation and as cover compensating in case of insufficient

cover (2 mm Rock Seal 777 (Elastic) is equivalent to 6 inches of concrete)

Elastic coating of precast concrete surfaces, subject to flexural loading and vibration, etc

Mixing:

Rock Seal 777 (Elastic) shall be mixed with a low speed (< 500 rpm) electric drill mixer. Pour the liquid component (A) into a suitable mixing container. While stirring slowly, add the powder component (B) to component A. Mix thoroughly for at least 3 minutes to the required consistency.

Application:

While the surface is still damp (no standing water)

apply the first coat and leave to harden

(2-6 hours). For slurry consistency, apply with a hard-plastic bristled brush or broom. For trowelable mortars, use a notched trowel. After the second coat has been applied, finish by rubbing down with a soft dry sponge.

Important Recommendations

Minimum ambient and substrate temperature+8

1. Never apply more than 4 kg/m2 for one layer.

Curing:

In severe heat and/or wind, protection of the Rock Seal 777 (Elastic) is recommended. As with all cement based products, curing is important. Protect newly applied product against direct sunlight, wind, rain and frost

Product Data:

Safety Instructions:

Ecology

Do not dispose of into water or soil, but according

to local regulations.

Transport

Non-hazardous.

Safety Precautions

Wear gloves and goggles. In contact with eyes or skin product, may cause irritation.

Toxicity

Non-Toxic under relevant health and safety codes.

Surface Preparation:

Concrete, mortar and masonry surfaces must be clean, free from grease, oil and loosely adhering particles. All surfaces must be as true and flat as possible. Saturate absorbent surfaces thoroughly with water before application.

Coverage:

Depending on type of application, two (2) coats always required. Three (3) coats may be required in areas of extremely high infiltration. 1st coat consumption 1-1.5 kg/m2 on damp surface.

2nd coat consumption 0.8 - 1 kg/m2 approx.

NOTE :

1. Packaging :                                      30 kg (A+B)
2. Storage Conditions :                      Free from frost and moisture.
3. Shelf Life :                                        12 months when unopened.